[Interface de communication]：RS485
[Distance de communication]： 5 km
[Tension]：DC 8-28 V
[Méthode d'installation]：Rail DIN
[Dimensions]： 113 x 37 x 65 mm
[Poids]：77 ± 5 g
[Introduction]：Le commutateur de transmission à distance sans fil est un terminal utilisant la technologie de modulation LoRa pour la transmission à distance sans fil de signaux numériques. Il prend en charge la collecte des entrées numériques (DI) et le contrôle des sorties relais (DO). Sa fonction principale est de réaliser un contrôle synchrone à distance sans câblage, offrant une grande simplicité d'utilisation et une intégration rapide aux systèmes des utilisateurs. Il accepte une entrée de 8 à 28 V CC et est doté d'un revêtement conforme pour une résistance à la moisissure, à l'humidité et au brouillard salin
Magasin officiel
| serial number | E860-DTU(1010-400SL22)-V2 Device Port Description |
| 1 | RS485-A |
| 2 | RS485-B |
| 3 | PE (protective earth) |
| 4 | DC 8～28V(V-) |
| 5 | DC 8～28V(V+) |
| 6 | Switch input port 1 |
| 7 | Switch common terminal |
| 8 | Relay output normally open port 1 |
| 9 | Relay output COM port 1 |
| 10 | Relay output normally closed port 1 |
| 11 | STATE configuration reset button |
| port | LED indicator color | illustrate |
| PWR | Blue LED | Power indicator light, always on when powered on, off when no power |
| LINK | Yellow LED | 1. 1 to many (including 1 to 1) - bidirectional (when the devices have the same number of channels): As long as one slave is successfully connected to the master, the master's LINK indicator is always on; after the slave is successfully connected to the master, the slave's LINK indicator is always on; |
2. 1 to many - two-way (different number of channels, each channel of the host is independently controlled by the slave): the number of times the host's LINK indicator flashes depends on the number of devices connected (cycle: 300ms, after flashing, it turns off for 1s, and then flashes again). For example: if 3 devices are connected, the LINK indicator flashes 3 times according to the cycle, then turns off for 1s and flashes again; | ||
| STATE (indicator light) | Blue LED | 1. Host: The indicator light is always on; |
2. Slave: indicator light flashes slowly; | ||
3. Pairing: The indicator light flashes quickly; | ||
4. Not paired: the indicator light is off; | ||
| STATE (button) | White buttons | 1. Press and hold for 2 seconds to enter pairing mode; |
2. Press and hold for more than 6 seconds to restore to factory settings; | ||
3. Press and hold to cycle through the pairing state and reset state; | ||
5. In pairing mode, short press to exit pairing mode | ||
| DI1-DI8 | Green LED | Device switch input data indication, normally on means there is input, normally closed means there is no input |
| DO1-DO8 | Red LED | Each of the 8 relay output switch indicators corresponds to the 8 relay outputs; normally on indicates output is in progress, and normally closed indicates no output. |