Nouveaux produits EN VENTE MagasinMagasinMagasin
Partager
English English
ENESCN
Home >Module>SPI/SOC/UART>Other
Wireless Module
high-speed transmission
star network module
Wireless Module
high-speed transmission
star network module

E70-915NW14S Solution de module Internet des objets sans fil 200 noeuds réseau Star hoc 915 MHz module émetteur - récepteur RF agriculture intelligente

[IC]：CC1310

[Fréquence]：915MHz

[Pouvoir]：14dBm

[Distance]：2.5km

[Taille]：16*26mm

[Poids]：1.65±0.1g

[Introduction]：E70-915NW14S est un module de réseau stellaire fonctionnant à 915MHz, basé sur les protocoles Ti cc1310 et 15.4-stack importés à l'origine, avec un coordonnateur et un terminal. Il existe des modes de transmission longue distance, standard et haute vitesse. Jusqu'à 200 noeuds peuvent envoyer des données à un coordonnateur.

Send Inquiry
Purchase
Téléchargements de fichiers Compare
1
No. Pin item Pin direction Application
1、16、27、41、42 GND Ground Ground electrode
3-15、23-24、29-31、33-34、36-40 NC Reserved pin Reserved, to be floated
2 ANT - Antenna (50 ohm impedance)
17 M0 Input M1M0 The four working modes of the module are determined by the joint combination. When in use, a 1K protection resistor shall be connected in series externally, and a 1M pull-up resistor shall be added (it shall not be suspended, otherwise, it can be grounded).
18 M1 Input M1M0 The four working modes of the module are determined by the joint combination. When in use, a 1K protection resistor shall be connected in series externally, and a 1M pull-up resistor shall be added (it shall not be suspended, otherwise, it can be grounded).
19 RXD Input TTL UART inputs, connects to external TXD output pin. Can be configured as open-drain or pull-up input. For details, please refer to parameter setting.
20 TXD Output TTL UART outputs, connects to external RXD input pin. Can be configured as open-drain or push-pull output. For details, please refer to parameter setting.
21 TMSC Input JTAG TMSC
22 TCKC Input JTAG TCKC
25 AUX Output To indicate module ’s working status & wakes up the external MCU. During the procedure of self-check initialization, the pin outputs low level. Can be configured as open-drain output or push-pull output, see parameter settings for details. A 1K protection resistor needs to be connected in series when using(it can be suspended)
26 VCC - Module power supply positive reference, voltage range: 2.2V ~ 3.8V DC
28 ACK Output The user indicates the data transmission result of the module, which is pulled down before transmission and pulled up after success. It can be configured as drain open circuit output or push-pull output. When it is used, a 1K protection resistor should be connected externally in series (it can be suspended).
32 RESET Input Module reset pin
35 LINK Output To indicate module ’s current network connection status. Can be configured as open-drain output or push-pull output, see parameter settings for details. A 1K protection resistor needs to be connected in series when using. (it can be suspended)