Nouveaux produits EN VENTE MagasinMagasinMagasin
Partager
English English
ENESCN
Home >Module>SPI/SOC/UART>CC13**
wireless transceiver module
TTL level output
CC1310 chip
wireless transceiver module
TTL level output
CC1310 chip

E70-900T14S2 IPEX/trou de timbre Ti 868/915 Mhz émetteur-récepteur récepteur TI CC1310 SoC Module sans fil

[CI]：CC1310

[La fréquence]：861~922.5MHz

[Du pouvoir]：14dBm

[Distance]：1.5km

[Taille]：14*20mm

[Poids du produit]：1.2g±0.1g

[Introduction]：Les modules d'émetteur-récepteur sans fil E70-900T14S2, fonctionnant à 861 ~ 922,5 MHz (par défaut: 868/915 MHz), sont basés sur le CC1310 importé à l'origine de TI, avec une sortie de niveau TTL, une tension de port IO de 3,3 V, une dérive industrielle haute précision à basse température de 24 MHz vibration cristalline; Assurer sa capacité industrielle et sa stabilité.

Send Inquiry
Purchase
Téléchargements de fichiers Compare
1
Pin No. Pin item Pin direction Pin application
1 GND Reference ground    Ground electrode
2 GND Reference ground    Ground electrode
3 GND Reference ground    Ground electrode
4 NC Keep the feet     Keep the feet Leave unused, to be suspended
5 NC Keep the feet     Keep the feet Leave unused, to be suspended
6 NC Keep the feet     Keep the feet Leave unused, to be suspended
7 NC Keep the feet     Keep the feet Leave unused, to be suspended
8 VCC -    Positive power reference，voltage range：2.2V ~ 3.8V DC
9 GND Reference ground    Ground electrode
10 GND Reference ground    Ground electrode
11 PA_EN Output    External PA control output, high level effective (hoverable)
12 LNA_EN Output    External LNA control output, high level effective (hoverable)
13 M2 Input    M2M1M0 together determines 8 working modes of the module. When used, a 1K protection resistor is connected in series externally
14 RESET Input    Reset pin
15 GND Reference ground    Ground electrode
16 AUX Output    It is used to indicate the working state of the module. The user wakes up the external MCU and outputs the low level during the initialization of self-check on power. It can be configured as open-drain output or push-pull output, as shown in parameter Settings (it can be suspended).
17 TXD Output   Can also be used as TTL serial output, connected to the external RXD input pin; It can be configured for open drain or push-pull output. See parameter Settings for details
18 TCKC Input    JTAG TCKC
19 TMSC Input    JTAG TMSC
20 RXD Input    TTL serial input, connect to external TXD output pin; It can be configured as open drain or pull up input. See parameter Settings for details
21 M1 Input    M2M1M0 combination determines 8 working modes of the module (not suspended, if not grounded)
22 M0 Input    M2M1M0 combination determines 8 working modes of the module (not suspended, if not grounded)
23 GND Reference ground    Ground electrode
24 ANT -    Antenna（50Ω characteristic impedance）