Nouveaux produits EN VENTE MagasinMagasinMagasin
Partager
English English
ENESCN
Home >Module>SPI/SOC/UART>CC13**
Wireless Module
CC1310 Chip
TTL level output
Wireless Module
CC1310 Chip
TTL level output

E70-433T30S Module RF sans fil Ebyte 433 mhz Soc Ti Module 433 mhz longue portée Cc1310 équipement de réseau sans fil

[CI]：CC1310

[La fréquence]：431~446.5MHz

[Du pouvoir]：30dBm

[Distance]：6.0km

[Interface]：UART/IO

[Lester]：4.8±0.1g

[Poids du produit]：4.8±0.1g

[Introduction]：E70-433T30S est un module émetteur-récepteur UART sans fil basé sur le CC1310 d'origine de TI, fonctionnant à 431 ~ 447 MHz, niveau TTL et port IO 3,3 V. Le module a la fonction de cryptage et de compression des données.

Send Inquiry
Purchase
Téléchargements de fichiers Compare
1
Pin No Pin item Pin direction Pin application
1-3、17、30、31、46、47 GND Ground Ground electrode
4-10 NC Reserved pin Reserved, to be floated
11 LNA_EN Output Internal MCU controlled LNA pin, valid in high level, connect to pin 44
12 PA_EN Output Internal MCU controlled PA pin, valid in high level, connect to pin 45
13-15 NC Reserved pin Reserved, to be floated
16 M2 Input M2, M1, M0 jointly decide the 8 working modes; an external 1k protective resistor shall be connected in series when in use.
18 M0 Input M2,M1, M0 jointly decide the 8 working modes;an external 1k protective resistor shall be connected in series and a 1M pull-up resistor shall be added when in use.(Cannot be floated, it can be grounded when not used)
19 M1 Input M2,M1, M0 jointly decide the 8 working modes;An external 1k protective resistor shall be connected in series and a 1M pull-up resistor shall be added when in use.(Cannot be floated, it can be grounded when not used)
20 RXD Input TTL serial port input connects to external TXD pin. It can be configured asopen-drain or high pull input, please refer to parameter setting. An external 1k protective resistor shall be connected in series when using.
21 TXD Output TTL serial port output connects to external RXD input pin. It can be configured as open-drain or push-pull input, please refer to parameter setting. An external 1k protective resistor shall be connected in series when using.
22 TMSC Input JTAG TMSC
23 TCKC Input JTAG TCKC
24 RESET Input Reset pin, valid in low level
25 NC Reserved pin Reserved, to be floated
26 NC Reserved pin Reserved, to be floated
27 AUX Output It is used to indicate the operation status of module, for user to wake up the external MCU, the module outputs low level during self-checking and initialization at power on, it can be configured as open-drain output orpull-up output, please refer to parameter setting part, an external 1k protective resistor shall be connected inseries when using.(can be floated)
28-29 VCC - Power positive reference, power supply 2.6V ~ 5.5V DC
32-43 NC Reserved pin Reserved, to be floated
44 LNA_EN Input Internal LNA pin,valid in high level, connect to pin 11
45 PA_EN Input Internal PA pin,valid in high level, connect to pin 12
48 ANT - Antenna (50Ω characteristic impedance)