Nouveaux produits EN VENTE MagasinMagasinMagasin
Partager
English English
ENESCN
Home >Module>SPI/SOC/UART>CC13**
Module émetteur-récepteur sans fil
Module émetteur-récepteur sans fil
Module émetteur-récepteur sans fil
Module émetteur-récepteur sans fil
Module émetteur-récepteur sans fil
Module émetteur-récepteur sans fil

E70-433T14S TI CC1310 Module émetteur-récepteur sans fil UART IOT de petite taille 1500m 433MHz RF

[CI]：CC1310

[La fréquence]：425~450.5MHz

[Du pouvoir]：14dBm

[Distance]：1.5km

[Interface]：UART/IO

[Poids du produit]：2.8g±0.1g

[Lester]：1.7±0.1g

[Introduction]：E70-433T14S, basé sur CC1310 de TI, est un petit module RF UART de type SMD avec interface IPEX. Il s'agit d'une plate-forme matérielle sans micrologiciel, les utilisateurs doivent donc effectuer un développement secondaire.

Send Inquiry
Purchase
Téléchargements de fichiers Compare
1
Pin No Pin item Pin direction Pin application
1 GND Ground Ground electrode
2 ANT - Antenna (50Ω characteristic impedance)
3-5 NC Reserved pin Reserved, to be floated
6 LNA_EN Output External LNA control output, valid at high level (floatable)
7 PA_EN Output External LNA control output, valid at high level (floatable)
8-14 NC Reserved pin Reserved, to be floated
15 M2 Input M2, M1, M0 jointly decide the 8 working modes; an external 1k protective resistor shall be connected in series when in use.
16 GND Ground Ground electrode
17 M1 Input M2,M1, M0 jointly decide the 8 working modes;an external 1k protective resistor shall be connected in series anda 1M pull-up resistor shall be added when in use.(Cannot be floated, it can be grounded when not used)
18 M0 Input M2,M1, M0 jointly decide the 8 working modes;An external 1k protective resistor shall be connected in series anda 1M pull-up resistor shall be added when in use.(Cannot be floated, it can be grounded when not used)
19 RXD Input TTL serial port input connects to external TXD pin. It can be configured asopen-drain or high pull input, please refer to parameter setting. An external 1k protective resistor shall be connected inseries when using.
20 TXD Output TTL serial portoutput connects to external RXD input pin. It can beconfigured as open-drain or push-pull input, please refer to parameter setting. An external 1k protective resistor shall be connected in series when using.
21 TMSC Input JTAG TMSC
22 TCKC Input JTAG TCKC
23、24 NC Reserved pin Reserved, to be floated
25 AUX Output It is used to indicate the operation status of module, for user to wake up the external MCU, the module outputs low level during self-checking and initialization at power on, it can be configured as open-drain output orpull-up output, please refer to parameter setting part, an external 1k protective resistor shall be connected in series when using.(can be floated)
26 VCC - Power positive reference, power supply 2.1V ~ 3.8V DC
27 GND Reserved pin Ground electrode
28-31 NC Reserved pin Reserved, to be floated
32 RESET Input Reset pin, valid in low level
33-40 NC Reserved pin Reserved, to be floated
41 GND Ground Ground electrode  
42 GND Ground Ground electrode