Nouveaux produits EN VENTE MagasinMagasinMagasin
Partager
English English
ENESCN
Home >Module>BLE>Other
Serial-to-Bluetooth Module 1
Serial-to-Bluetooth Module 2
Serial-to-Bluetooth Module 3
Serial-to-Bluetooth Module 1
Serial-to-Bluetooth Module 2
Serial-to-Bluetooth Module 3
E104-BT56SP Module série vers Bluetooth, antenne PCB intégrée, portée de 150 m, mode maître-esclave intégré, faible consommation, BLE 5.3, configuration des paramètres OTA

[Fréquence]：2,4 GHz

[Protocole de communication]： BLE 5.3

[Portée de communication]：150 m

[Type d'antenne]：PCB intégrée

[Dimensions]：10*14.5mm

[Poids]： 0,5 ± 0,1 g

[Introduction]：The E104-BT56 series modules are serial-to-BLE Bluetooth modules designed based on the Bluetooth 5.3 protocol. They support Master, Slave, Master-Slave (Dual-role), and Observer modes, accommodating up to 8 simultaneous connections. These modules also support features such as low-power advertising, transparent data transmission, over-the-air (OTA) configuration, and OTA updates, making them suitable for applications in smart wearables, home automation, and more.

Send Inquiry
Purchase
Téléchargements de fichiers Compare
PIN
Serial Number Pin Definitions Pin direction illustrate
1 GND - power ground
2 NC - Users don't need to worry, it's suspended.
3 RESTORE enter After the internal pull-up switch is held low for at least 5 seconds, all parameters are reset to factory settings and the module automatically restarts.
4 DATA Output Data output indication: A high-level signal is output upon receiving BLE data over the air, and a low-level signal is output after the BLE data has been transmitted via serial port.
5 LINK Output Connection status indicator pin: high level indicates connected, low level indicates disconnected.
6 NC - Users don't need to worry, it's suspended.
7 RESET enter Reset pin, low level reset
8 WRP enter The default low level indicates normal mode, during which serial communication is possible. Pulling it high enters sleep mode, and serial communication is disabled. (Edge triggered)
9 RXD enter Serial port input
10 TXD Output Serial port output
11 GND - power ground
12 VCC enter Positive power supply, 1.8V~3.6V, 3.3V power supply recommended.
13 NC - Users don't need to worry, it's suspended.
14 NC - Users don't need to worry, it's suspended.
15 LOG_TX Output Log serial port output is disabled by default; it can be left floating if not used.
16 NC - Users don't need to worry, it's suspended.
17 NC - Users don't need to worry, it's suspended.
18 GND - power ground